PDA

View Full Version : Starboard ballast reads full??


Millertime
09-16-2013, 03:10 PM
I noticed this weekend the ballast levels on my Vdig screen were stuck on full(starboard). I know the tank is empty, I emptied it on the trailer. Is there a way to rest? Is there a sensor inside the tank that may have to be replaced. Thanks in advance.

MattsCraft
09-16-2013, 04:36 PM
There is a float for each tank. For the rears it is in the rear locker, you will find a small carpeted access panel, remove the screws and under it is the float. The float could be stuck, possible loose wire on the sender or the sender is bad. (Most likely)

On my '09, I had one that never showed completely full. I never found any calibration screw for he float:confused:

Millertime
09-17-2013, 12:48 AM
Great thanks for the help! I'll have a look tomorrow.

Kell
07-03-2016, 04:56 PM
Anyone have a part number for port ballast tank sensor on 09 x2 MCX. Cost and online place to order. Mine is filling and emptying but vdig shows 1/4 full all the time.


Sent from my iPhone using Tapatalk

Kell
07-07-2016, 11:26 AM
Update. My issue turned out to be a stuck float. Took it out and cleaned up the float and the shaft it travels on and works fine now.


Sent from my iPad using Tapatalk