PDA

View Full Version : ballast winterization?


packman312
09-15-2013, 10:14 PM
Is there an easy way to know which ballast intake feeds which tank (port, center, strbd)? Also, is there any issues with running a pump dry for a few minutes if I cant easily determine the former. Thanks in advance!

Packman

ttu
09-15-2013, 10:30 PM
pack, I have the winterizing instructions at my office. I will post them for you tomorrow morning.

Mastercraft13
09-16-2013, 12:39 AM
I was going to do mine in reverse, I thought I seen a posting where you dump about a half a gallon through the vents and hit to drain the a/f through the pumps. Correct me if I'm wrong.

ttu
09-16-2013, 10:54 AM
here you go.

Baszy
09-17-2013, 11:20 PM
Ttu, great help. Thx for the PDF!

packman312
09-18-2013, 11:58 PM
Ttu, thanks for pdf. I dont know exactly which switch runs which port thru where the funnel is used. Can i run them dry for a minute to determine or is this bad for motor? Any other way to determine?


Packman