PDA

View Full Version : Added pump to existing swith and wiring, runs 5 seconds and stops


HartlandX1
07-14-2013, 08:23 AM
2007 x1 originally had two rear pumps. Had a third switch that wasn't being used but was wired. Added a third pump and connected wiring. When I run the pump it works for 5 seconds then shuts off and the light blinks. I know there is water pumping for those 5 seconds because I have quick disconnects and pumped water out for those five seconds. Brand new pump. Any ideas? Thanks

hughes26
07-14-2013, 08:39 AM
Does the 07 have timers for the pumps like the newer models?
Might be as simple as extending the timer for the 3rd pump.

HartlandX1
07-14-2013, 08:48 AM
Does the 07 have timers for the pumps like the newer models?
Might be as simple as extending the timer for the 3rd pump.

Yes it does. How do I do that?

hughes26
07-15-2013, 10:52 PM
I'm not sure on an 07, but I'm sure someone in this forum does.

JRW160
07-16-2013, 01:57 PM
http://www.mastercraft.com/teamtalk/showthread.php?t=24956&highlight=ballast+timer+reset