PDA

View Full Version : What do my dash switches do?


Topp dawg
06-26-2013, 02:15 PM
I have a 2003 X10 and my switches are faded and I dont know what they do. Some of them say ACC but most of them are not readable. I am talking about the switches under the key. Can anyone tell me what they do? Also I want to replace them so if anyone has some they would like to sell, let me know. My switches work just fine so I only need the covers.

André
06-26-2013, 02:26 PM
Turn them on and see what they do!
You have a blower,bilge pump,nav lights,anchoring light,heater...and probably 2 acc. switches.Radio and depth finder may have been wired through those 2.
Is the boat new to you:confused:

Aric'sX15
06-26-2013, 02:36 PM
Should be ballast, if below the dash!

bjen
06-26-2013, 04:36 PM
Try here, the 2003 manual is a terrible copy but check the 2004 one-perfect copy and should be similar, it is for my X2

http://www.mastercraft.com/knowledge/owners_manuals

Topp dawg
06-26-2013, 09:42 PM
Yes, the boat is new to me. I got it a few weeks ago.

cwnewsom
06-29-2013, 05:22 PM
I have the same issue in my '03 X30. Lmk what u find out

X25John
06-30-2013, 09:54 AM
I had a 2004 X10. As I recall there were 2 or 3 ACC switches that were not used. The switch directly under the key is NAV/ANC. The one to the right of that switch is the bilge pumps. Pushing the top of it is the forward bilge and the bottom is the aft bilge. To the right of that switch is a ACC. The two left most switches were ACC as well. I had tower speakers and connected both amps to the left two individual ACC switches. This enabled me to work the tower and in boat speakers independently. Hope this helps. I tried to upload a picture but was unsuccessful.

Topp dawg
07-01-2013, 02:57 PM
Thanks man. I did not know the up and down bilge button controlled 2 different bilges. I thought the up button turned it to manual and the middle was off and the bottom setting would turn it to automatic.

X25John
07-01-2013, 08:20 PM
Just leave it in the middle and it will be automatic.