PDA

View Full Version : Anyone have a spare 53" x 1" drive shaft?


john jones
05-26-2013, 10:53 PM
This project started with a change of my rear main seal. I decided since I needed to remove the transmission I would pull my prop shaft and replace the cutlass bearings inside the strut. While removing the driveshaft I noticed that it is bent at the prop end.

Does anyone have a good used one they would like to sell? I can order one from skidim, just thought I would ask here first.

Boat is a 93 maristar 225 direct drive 1:1 trans. I measured it, from thread to thread it is 53".