PDA

View Full Version : Tightening stock steering wheel


buckyten
12-02-2012, 08:50 PM
Have a 2003 prostar 205V steering wheel nut is real tight but still wiggles a little, any suggestions, thanks

tph
12-03-2012, 03:26 AM
Is the wheel loose on the shaft or is the shaft assembly moving (loose)?

mikeg205
12-03-2012, 08:58 AM
Not sure which helm the 2003 has - however it if you take off the steering wheel and the room the plastic cowling it will expose the helm steering joint. There might be - mine has it but I have an older boat - a hex head bolt to tight the helm assembly. There also might be two depending on model. See picture - arrow pointing to bolt.

buckyten
12-03-2012, 01:54 PM
Thanks, loose on the shaft

thatsmrmastercraft
12-03-2012, 02:01 PM
Now that is quick problem solving. Welcome aboard buckyten.

pram
12-03-2012, 02:29 PM
Dang Mike, I didn't know that

good info

mikeg205
12-03-2012, 02:34 PM
Dang Mike, I didn't know that

good info

I got lucky...was bored on a Sunday afternoon and I checked mine out...you know that MCOCD take it apart thing...hopefully get it together...

Kyle is right - I am a 13...if I had more $$$ I'd have to be committed...lol.

thatsmrmastercraft
12-03-2012, 02:35 PM
I got lucky...was bored on a Sunday afternoon and I checked mine out...you know that MCOCD take it apart thing...hopefully get it together...

Kyle is right - I am a 13...if I had more $$$ I'd have to be committed...lol.

Correction..............if you had more money, you would be eccentric.:rolleyes:

mikeg205
12-03-2012, 02:47 PM
Correction..............if you had more money, you would be eccentric.:rolleyes:


:uglyhamme:uglyhamme:uglyhamme