PDA

View Full Version : 85 S&S Dash Fuses


xtnkshun
07-20-2012, 08:22 PM
Hello TT'ers,

I need a HUGE favor. Can someone out there tell me what size fuses they have for their dash fuses? I am worried that the PO but the wrong sizes in and could risk burning something up.

Blower Fuse
Pump Fuse
Auto Fuse
Nav Fuse
Anchor Fuse

Horn fuse
Above Ignition fuse (not sure what this fuse is for until I get under the dash.)

THANK YOU!!!

BDF2
07-21-2012, 06:11 AM
I e-mailed Discount Inboard Marine (skidim.com) a couple of years ago when I needed to replace the fuses on my '86. Also, let them know which engine you have. They responded very quickly with their part numbers and sizes. They were a direct replacement and could not have been easier to install.

DH9441
07-21-2012, 09:13 AM
I think 20 Amp

tlukens
01-17-2013, 08:24 AM
Hello TT'ers,

I need a HUGE favor. Can someone out there tell me what size fuses they have for their dash fuses? I am worried that the PO but the wrong sizes in and could risk burning something up.

Blower Fuse
Pump Fuse
Auto Fuse
Nav Fuse
Anchor Fuse

Horn fuse
Above Ignition fuse (not sure what this fuse is for until I get under the dash.)

THANK YOU!!!
I was wondering the same thing. I just replaced all the fuse holders in my boat. They were weathered and some of the fuses inside were corroded to the point that they broke when pulling them out of the holder. I can't read what amp the fuses are. I want to make sure I put the proper amp fuses back in.
1985 Skier
351 PCM
1.52 Transmission

xtnkshun
01-17-2013, 08:54 AM
I don't have my boat nearby, but I think I went with 10s across the board. Boats been in the water multiple times since then with no problems.

tlukens
01-17-2013, 09:42 AM
I don't have my boat nearby, but I think I went with 10s across the board. Boats been in the water multiple times since then with no problems.
Thanks, I pulled a 30 amp out of the horn fuse. That seemed a little high

reftech
01-17-2013, 10:41 AM
I would think ten amp fuses would be sufficient..thirty is a little much..Just my 2 cent

thatsmrmastercraft
01-17-2013, 10:49 AM
A quick look on Overtons site showed their electric horns rated at 3 amps. 10 amp fuse would be more than sufficient.

madcityskier
01-17-2013, 10:50 AM
I can check tonight, but 30 sounds a might high. I'll try to give them a look when I get home.

madcityskier
01-17-2013, 10:53 PM
Found a 25 in the NAV a 15 in the ANCHOR. The rest are 20's. Seems odd, but I have strong faith in the previous owner. I will check my manual tonight looking for confirmation.

madcityskier
01-17-2013, 11:38 PM
Nothing in the manual, did find an old thread on this topic.

http://www.mastercraft.com/teamtalk/showthread.php?t=1574

tlukens
01-19-2013, 12:11 PM
Thanks

gsxrjtt
02-08-2013, 06:36 PM
Hey does any one know where to get new fuse holders for an 85 S&S 351 ... want to replace holders and redoing the toggles with push button red LED switches..