PDA

View Full Version : rocker switch for the bulge pump


Bob B
05-18-2012, 05:25 PM
Does anyone have a wiring diag. of the rocker switch for the bulge pump on a 2002 prostar197
that you can share?
Thanks

Bob B

petermegan
05-18-2012, 06:01 PM
My bulge comes up without a pump.:uglyhamme

Bob B
05-18-2012, 06:48 PM
Petermegan,
The old pump had 2 positions, on and auto.,
4 wires. I ordered a replacement and it only has 3 wires.
When I wire it the way I think it should go, it will run in one position and throw the breaker in the other pos. I called the Mfg. they could not help because they don't know how the rocker is wired.

ricford
05-18-2012, 11:26 PM
79048
Not an official MC diagram, but its the basic info. Don't know why the original would have 4 wires.

ricford
05-18-2012, 11:34 PM
79049
Maybe this is it.

petermegan
05-19-2012, 08:39 PM
Sorry Bob, can't help you with that. Was only being sarcastic at your 'bilge' problem. Ricford has it covered. good job.

Bob B
05-19-2012, 09:48 PM
FYI, the new pump has three wires. (See Diag).
Been in contact with my Mastercraft dealer. (200 mile away)
He gave me some suggestions.. So I’ve pulled the dash to check wiring on rocker switch, Blew the circuit breaker. I have a spare circuit breaker in the panel.. But good old MC used one different one in the panel. Guess which one that was? Will be ordering a bilge pump breaker Monday.



http://www.mastercraft.com/teamtalk/picture.php?albumid=684&pictureid=4077