View Full Version : Wetsounds Pro80s and Syn6

04-10-2012, 09:59 PM
I have a pair of Pro80s that I purchased for my last boat which was a 2011 Super Air Nautique 230. The tower failed after a few months and they initially said it was due to the speakers and they warrantied the tower but told me they would not again if I did not remove the speakers. Turned out they ended up completely redesigning the tower latch system and it was never the speakers any way. In any case, I had already replaced them and they have been sitting in my Garage ever since. I have all new stuff coming for my new x25 on order :) so its time for them to go. The Pro80s were over 1k after tax shipping etc and have very little use. Im thinking around 800.00 for the speakers.

I also have a syn6 which will run these two speakers and a sub really good or all interior speakers and a sub. You will end up getting 200watts rms to each tower speaker and depending on Ohm load and configuration of your subs up to 600 watts rms. This amp was 900 plus tax and shipping new and I would like to get around 750 for it. All this stuff looks and sounds great and got very little use. Its close to brand new. let me know if you have any questions.

Here is a picture of the amp and I will get some pics of the speakers tomorrow.


04-11-2012, 12:12 PM
More pics

http://bankflow.s3.amazonaws.com/wamp.jpg http://bankflow.s3.amazonaws.com/top.jpg http://bankflow.s3.amazonaws.com/side.jpg http://bankflow.s3.amazonaws.com/frontup.jpg http://bankflow.s3.amazonaws.com/front.jpg