04-10-2012, 02:59 PM
I have a 07 VRS 200. I bought a used ZFT3 tower. Cannot find installation instructions anywhere not even from Dealer or from Mastercraft TN. Anybody know of or have any.
04-10-2012, 08:48 PM
I didn't have any instructions when I installed my tower either. Nor have i seen any.
Assuiming the tower is an exact match to the boat, the 200 (X2) will have reinforced tower mounting areas under the deck I believe.
Best bet, find someone locally with an X2 that will let you crawl around and take some measurements. (Although if you set the fully assembled tower onto the boat, it will really only "fit" well when it's in the right spot.)
As far as the actual install, there are some threads on here with instructions, peoples experiences. Bottom line, measure 3x, drill once! Run you drill bits backwards thru the gelcoat and then chamfer the edge of the gel once your hole is to size, both to eliminate chipping and cracking of the gel.