PDA

View Full Version : fibreglass swim platform rubber


chopp
03-25-2012, 12:02 AM
Has anyone had any problems the with mastercraft logo rubber piece slowly peeling off the fibreglass swim platform . If so , or if you have any recommendations, what should i use to stick it back down with . its a 2011 x2.
thanks

sand2snow22
03-25-2012, 12:09 AM
Seadeck. I just replaced with a Seadeck on a 2007 X-2, grey with another shade of grey Mastercraft logo. $240 shipped though :(

http://www.seadek.com/

chopp
03-25-2012, 12:19 AM
thanks mate , they look good , bit pricey though , website says 240 + logo + shipping

Kevin@MWMC
03-25-2012, 09:27 AM
If you just want to glue your stock one back to the platform, this is what I did. Also a couple threads you can look into as well discussing this.

I personally used 3M 5200 MARINE ADHESIVE to glue mine back down. Then put a line of caulk around the edge. Been holding for over 2 years now with no problem.

Only down side is the 3M 5200 MARINE ADHESIVE has a 7-day cure time. Definitely worth it though. I did it in the off season so it wasn't an issue.


Here are a couple threads with more info:

http://www.mastercraft.com/teamtalk/showthread.php?t=43216&highlight=swim+platform

http://www.mastercraft.com/teamtalk/showthread.php?t=42245&highlight=marine+adhesive



Sent from my iPad using Tapatalk