PDA

View Full Version : Help removing starboard panel


BallBushing
03-17-2012, 06:18 PM
I'm having all the vinyl being redone and am down to removing the last piece, the starboard side panel that contains the throttle assembly.

My problem is getting the throttle assembly out of the side panel and I'm wondering if I have to remove four hex bolts from the back side of the assembly the to get it out.

Attached are pics showing the side panel almost off, the throttle from the front and the backside of the throttle. Not sure what to do, any suggestions?

BallBushing
03-18-2012, 05:14 PM
54 views and no suggestions!. Never mind, removed the 4 hex screws and the back plate came off clean. No springs or small parts back there.

Table Rocker
03-19-2012, 02:08 AM
I'm guilty of a view, but I have no idea how it is done. My ProStar is the opposite with the pad bolting in front of the control. The fiberglass my control is mounted on does not move and doesn't have to. I suspect other "viewers" were in a similar situation.