PDA

View Full Version : 1st attempt at fiberglassing...


agarabaghi
10-15-2011, 06:40 PM
Well decided to get away from gluing and went with fiberglass. Decided it would easier to secure it to the hull if it sat on the floor, so that's how it went. Used 3 brass L shaped pieces to secure the bottom, even though before putting them on it was strong enough to punch without it moving.

Ive also started to clean up the wiring and battery terminals. I will have 2 distribution blocks also splitting the grounds and power for the amps, as well as 2 batteries and an isolator. I will recarpet and mount the amps / blocks tomorrow.

The wetsound amp will remain in the same place as it;s help up good. The Cadence A7HC and the JL m2150 will be mount on the black starboard, while the 2 distribution blocks will be mounted on the white board above.

http://img190.imageshack.us/img190/5444/imagerds.jpg

http://img717.imageshack.us/img717/5305/imagesmu.jpg

http://img8.imageshack.us/img8/4884/imagexnu.jpg

http://img684.imageshack.us/img684/1889/imageuaw.jpg

agarabaghi
10-15-2011, 06:41 PM
http://img641.imageshack.us/img641/8097/imagetqas.jpg

http://img204.imageshack.us/img204/2258/imagecsr.jpg

http://img51.imageshack.us/img51/8025/imageime.jpg

agarabaghi
10-16-2011, 04:52 PM
http://img69.imageshack.us/img69/6013/imagedhos.jpg

http://img267.imageshack.us/img267/4013/imagezrp.jpg

http://img687.imageshack.us/img687/2658/imagedtw.jpg