View Full Version : ignition control module
Mogaharley
08-14-2011, 11:58 AM
Looking for a part number for an ignition control module for a 1991 prostar. Could use the coil number too. I believe it to be a prestolite distributor. thanks,
Spork
08-14-2011, 12:31 PM
If its original it has points not electronic ignition. you will probably have to get a new electronic ignition conversion and just start over, you could look under the cap time see if its been upgraded at some point and see if there is any part numbers.
Mogaharley
08-14-2011, 12:42 PM
Never would have thought of that... Can't see any part numbers left on the Distributor. Any suggestions on what might fit it?
Thanks
Spork
08-14-2011, 12:50 PM
Check out www.skidim.com they sell ei conversions and the coils and resistors you will need
http://www.skidim.com/products.asp?dept=1113
Spork
08-14-2011, 12:56 PM
Check out this thread it has good information on changing to ei
http://mastercraft.com/teamtalk/showthread.php?t=3533
Mogaharley
08-14-2011, 05:09 PM
Thanks again, found one on Marine engine parts.com. Seems like it will work out.