PDA

View Full Version : Edelbrock intake manifold with egr


d36yzrider
08-12-2011, 11:31 AM
I just picked up a used 351 Edelbrock intake manifold for 80 bucks off craigslist for my 84 S&S cant wait to bolt it on anyways this manifold has hole for the egr valve where on the stock manifold where the hole is it was never cut out anyway can I just block it with a gasket and plate?

j.mccreight@hotmail.com
08-12-2011, 12:00 PM
Yes thats all that you have to do.

thatsmrmastercraft
08-12-2011, 01:47 PM
It may be best of you can get an aluminum plate. Anything steel will end up with corrosion. Don't go too thin on the aluminum.

j.mccreight@hotmail.com
08-12-2011, 02:23 PM
http://m.summitracing.com/parts/ACC-74203S

thatsmrmastercraft
08-12-2011, 02:58 PM
http://m.summitracing.com/parts/ACC-74203S

Wow, they are mighty proud of that. A small piece of 1/4" aluminum plate and a few minutes time would get the job done.

j.mccreight@hotmail.com
08-12-2011, 03:52 PM
Yep, I think I would make my own as well.