View Full Version : 05 197 perfect pass gauge went through dash

09-21-2010, 05:40 PM
today I was programming perfect pass and gauge went through dash. there are 2 aluminum flat brackets with screws that mount gauge to dash from the backside. these alum. brackets are really to short as they only catch just the edge of the rear of the gauge. on the small gauges these brackets work ok. on the speedometer, rpm and perfect pass these brackets are to short. does anyone have any input? local mastercraft dealer is no help

09-21-2010, 05:44 PM
Had the same problem with the speedometer on the same boat. If I recall, I got some screws from the local hardware store that were a touch longer. I think I may have custom rigged additional support with some washers as well. But, yes, it is a weak design.