PDA

View Full Version : Carburetor Gaskets


zekedog
08-16-2010, 04:49 PM
Putting a 4160 on an Edlebrock Perfomer. I bought the Edelbrock adapter plate that mounts on the intake with attached gasket. Gasket covers the base only. Here's my questions. In the stock set up the carb, spacer, and intake all had the same four 1 inch holes. The Edelbrock intake doesn't have the 4 holes, just two sides separated. As long as the gaskets seal the base and spacer outer perimeter does it matter if they match up to the carb and spacer 4 hole pattern? Thanks