PDA

View Full Version : Fuel Sender


TCrate
06-19-2005, 10:45 PM
I have a 92 Prostar with the 285 HO motor. I replaced the fuel sender last year with a cheap model. I found the old one on the shelf the other day and now understand that I can weld the magnets back in place to get it to work. What I do not know is where do these magnets go. There is a semicircular slide that rides up and down the shaft. I assume it goes on the flat side of this slide. Does JB weld work on these? Thanks for any input. By the way to replacement works but it is not very accurate. It is about a 1/4 tank off. :uglyhamme