PDA

View Full Version : 1995 Prostar 190 prop?


wakesurfer
10-24-2009, 08:55 PM
Hi, I need help figuring out what prop is on my boat, the three blade prop is bent at the ends, I cant figure out what pitch etc....and I would like to get another one some time soon, that would be more suited to wakeboarding and wake surfing. All I could discern from the prop was the following:

1094 IF6END or LEGEND ...SON


thanks for your help

coz
10-24-2009, 09:59 PM
Hi, I need help figuring out what prop is on my boat, the three blade prop is bent at the ends, I cant figure out what pitch etc....and I would like to get another one some time soon, that would be more suited to wakeboarding and wake surfing. All I could discern from the prop was the following:

1094 IF6END or LEGEND ...SON


thanks for your help

I'll betcha Eric from here http://www.ojprops.com/home will be here shortly to answer your question :D

TMCNo1
10-25-2009, 08:50 AM
Go directly to the man that knows, Eric Johnson @ http://www.ojprops.com/contact_us or contact him by pm, EJ OJPROP, http://www.mastercraft.com/teamtalk/member.php?u=1537
Be prepared to give him any info he may need like, current prop info off the hub, the current altitude you use the boat at, baseline numbers of the speeds and RPM's for the current prop, boat model and year, engine size, transmission ratio, function (skiing, barefooting, surfing, boarding, tubing, etc.), ballast use, fuel load, gear, nominal # of passengers, etc. He will need it to determine the best prop for your application.

wakesurfer
10-25-2009, 11:25 AM
Thank you very much.

EJ OJPROP
10-26-2009, 07:45 AM
The info you gave is on the side of the hub, prop was made in October of 1994. Let me know what is marked on the face of the hub, behind the prop nut, the size is stamped there. Or, I need more info on the motor and the gear ratio of the tranmission.

EJ

wakesurfer
10-28-2009, 08:18 PM
The info you gave is on the side of the hub, prop was made in October of 1994. Let me know what is marked on the face of the hub, behind the prop nut, the size is stamped there. Or, I need more info on the motor and the gear ratio of the tranmission.

EJ

Thank you very much for your help , the engine is Chevy 350 EFI not sure on gear ratio of tranny, btw could you tell me I know this sounds ignorant but ...how do I get the prop nut off to see the markings behind it? thanks, without damaging the shaft etc..

Chicago190
10-28-2009, 08:53 PM
Thank you very much for your help , the engine is Chevy 350 EFI not sure on gear ratio of tranny, btw could you tell me I know this sounds ignorant but ...how do I get the prop nut off to see the markings behind it? thanks, without damaging the shaft etc..

Wood block between the prop and the strut to stop it from turning and a large crescent wrench.