PDA

View Full Version : safety brake wire


rodltg2
06-01-2005, 01:10 AM
pulled a dumb move. i was in hurry to get my trailer off the hitch and i forgot to disconnect the safety brake wire . as i drove off it pulled right off the trailer. is there anyway to attach it back. i dont even remember where it came from.

milkmania
06-01-2005, 01:30 AM
IF it's anything like my travel trailer solonoid, there's a little black box that the plunger plugs into....

other than that, I dunno:o

jayocheskey
06-01-2005, 02:13 AM
About 6 inches behind the ball lock and release, there are two bolts. The safety cable is connected just in the front/center of those two bolts. There should be a piece of sturdy plastic where the cable should be attached.

jrbrown
06-01-2005, 08:06 AM
How about a few pics of the result. We can go from there.

Tom023
06-01-2005, 10:34 AM
This may sound insulting but did you check to see if you have a manual for the coupler? I got one with my boat and there are specific directions for replacing the wire. Mine has special clips that need to go on after it has been activated. They even supplied a few extras taped to the manual cover.

east tx skier
06-01-2005, 01:02 PM
Reminds me that I need to reattach the hook to mine. Not doing me much good in its present condition.

FrankSchwab
06-01-2005, 01:24 PM
Mine has special clips that need to go on after it has been activated. They even supplied a few extras taped to the manual cover.

Hey Tom -
Do you have the UFP coupler? I have one under the 98 Maristar I recently purchased, and of course didn't get the extra clips. Are they just small E-Clips like these? (http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXAMF6&P=M)

Tom023
06-01-2005, 02:12 PM
Yes, I have the UFP coupler and the clips look like those but I don't know the correct size.