View Full Version : Adjusting 2007 xstar tower....spanner wrench

06-15-2009, 09:27 PM
Does anyone know how to adjust a 2007 xstar tower? Towards the bow of the boat, where the tower is attached to the the hull, there appears to be an adjuster type of ring that uses a spanner wrench. My tower seems loose in this area and I would like to tighten it. My dealer is 80 miles away and I would like do it myself....

06-15-2009, 11:22 PM
do you drop the tower a lot? Mine is loose as well, but I'm not worried as much since I drop it everytime to put it in and out of the garage. It will eventually come loose again. I think being a bit loose helps me fiddle with it much easier to put the tower back up. Just my two cents! :)

but I would like to know where to get one of the wrenches to besides pulling the boat all the way to the dealer.

06-16-2009, 02:43 AM
To tighten or loosen the locking ring, first loosen the 3 set screws with an allen wrench then use a spanner wrench like this...


12-03-2011, 09:02 AM
EK.....can you find one for me thats "just laying around".............:rolleyes:

12-05-2011, 02:31 AM
I'll look around.....