PDA

View Full Version : Tolerance on shaft runout - MasterCraft 205V


Sawbo
02-10-2009, 07:39 AM
What is the allowable runout on the shaft midpoint between the strut and where the shaft passes through the hull? (place dial indicator at the midpoint of shaft and rotate the shaft)

Thanks in advance for the assitance.

JLeuck64
02-11-2009, 01:33 PM
These guys build replacement drive shafts that are straight!

http://www.elberts.com/system.htm

2 thousandths of an inch runout as measured over a 42 inch span. I think that is a much tighter tolerance than stock...