PDA

View Full Version : prop


bainez23
09-22-2008, 05:07 PM
2003 x-2 i need to take my prop off does anyone know if i have a spline shaft or tapered and if i will need a prop puller or not?

TMCNo1
09-22-2008, 06:20 PM
2003 x-2 i need to take my prop off does anyone know if i have a spline shaft or tapered and if i will need a prop puller or not?


'03 should be tapered shaft, you'll need a prop puller and removal should be covered here, http://www.mastercraft.com/teamtalk/showthread.php?t=26569, in the search link in post #2.

KHall
09-23-2008, 07:13 AM
My 03 x-2 has a splined shaft, i used puller because it was tight, and convienient. Think it could be removed w/o puller if u are careful.

bigmac
09-23-2008, 07:42 AM
I believe it has a splined shaft. I supposed it's possible that it is corroded at little and may therefore be a little tough to remove, but I would think that a tap or two with a non-marring mallet is all you'd need. When I changed the prop on my 04, it slid off into my lap as soon as I removed the nut. When you reinstall, put a thin coat of grease on the shaft.