PDA

View Full Version : 2001 x-9 prop


Vista Demo
09-07-2008, 11:43 PM
I bought a 2001 x-9 and i took it out for the first time last week. I noticed it was turning very low rpm's so i called and asked the guy i bought it from what the deal was. He said he replaced the prop in a pinch and does not think that is the right prop. What is the right prop. It has the LTR 350 with a 1:1 ratio. Any help would be great.

wakolman
09-07-2008, 11:54 PM
Get in touch with Eric @ OJ props on this board. EJ OJPROPS

http://mastercraft.com/teamtalk/member.php?u=1537

I don't know how to make his user id a link, sorry!

TMCNo1
09-08-2008, 12:12 AM
http://www.ojprops.com/contact_us

EJ OJPROP
09-08-2008, 06:31 AM
I bought a 2001 x-9 and i took it out for the first time last week. I noticed it was turning very low rpm's so i called and asked the guy i bought it from what the deal was. He said he replaced the prop in a pinch and does not think that is the right prop. What is the right prop. It has the LTR 350 with a 1:1 ratio. Any help would be great.

Our 13 X 13 LC 1" FORCE 4-blade would have been the original prop. Can you define "low RPM"? What is the size of the current propeller? Do you run the boat at an elevation above 2500 feet?

Eric

Vista Demo
09-08-2008, 11:07 PM
I could not get the boat above 3500 rpm's. Yes I was above 2500 ft but my buddy had a 2001 x- 10 same motor and was running like 5500 rpms and pulled away much faster than me. I dont know the curent prop size there is no markings that i can find.

EJ OJPROP
09-09-2008, 06:06 AM
I could not get the boat above 3500 rpm's. Yes I was above 2500 ft but my buddy had a 2001 x- 10 same motor and was running like 5500 rpms and pulled away much faster than me. I dont know the curent prop size there is no markings that i can find.

The size of the prop should be stamped on the face of the hub. I would suggest our 13 X 11 LC 1" XMP 3-blade to start.

Eric