PDA

View Full Version : adjust indmar motor mounts


Dave Gegel
07-10-2008, 08:57 PM
Can't get trans to line up with driveshaft flange. Up and down easy but left to right on go.:(

JimN
07-10-2008, 09:13 PM
Loosen the hold-down bolts for the mounts and use a 2x4 to nudge it over. You can also drop one side and raise the other to shift it to one side.

Jerseydave
07-10-2008, 09:16 PM
Tell us more.........is this after an impact with something under water? If so, maybe your strut is bent. (just thinking:D)

Dave Gegel
07-11-2008, 12:43 AM
bought this boat with 165hr, used it one time slite vib real slite, checked drive shaft alinement,seemed to be off, the mounts seem to run out of travel (moved all the right in the rear ) close but still needs to move to the right. shaft straight -strut? I think ok but I'll check. This boat is supper clean with no damage that I know of. The flange was about .010" off when I first checked, it's down to .004-.005" now . proubly close enough but like to see .003". It may have been off from Mastercraft.: