PDA

View Full Version : 2007 Tower Speaker Help


Bigheadtod
10-06-2007, 10:12 PM
2007 X45, one of my tower speakers is loose and moves around in rough water, can anyone explain how to tighten it up or is there a diagram or manual I can look at, it looks like 4 allen screws would drop it down and I could tighten, also a 2 scews on the side??? Help.

jaysus
10-06-2007, 10:41 PM
2007 X45, one of my tower speakers is loose and moves around in rough water, can anyone explain how to tighten it up or is there a diagram or manual I can look at, it looks like 4 allen screws would drop it down and I could tighten, also a 2 scews on the side??? Help.


Use an allen to unscrew the JL speaker from the can. Take the speaker out, disconnect tweeter, woofer, and pos/neg jumpers keeping in mind which one is which.

Put the allen wrench through the small hole on the bottom of the threaded receiver for the large nut connected to the tower. Get a wrench and tighten, holding the allen wrench in the other hand to keep the threaded receiver from spinning while tightening. Tighten can to tower.

Reverse procedure and your done.

Bigheadtod
10-06-2007, 10:51 PM
ok, I will give it a shot. Thanks.

A Cresent wrench for the other part?