PDA

View Full Version : 2006 X2 Tower Speaker Install


zeus12
05-16-2007, 09:57 PM
Getting ready to install tower MC factory tower speakers on a 06 x2. I have to drill the tower and run the wires down. Does anybody have any advice on getting the speaker wire from the tower down to where the amps are. Does this require a hole in the fiberglass?

One other question, dont all 06 X2's come with a amp straight from the factory? My boat just has 4 speakers and a head unit, no amp or sub.


Thanks a lot

cst573
05-16-2007, 10:02 PM
I just installed an ND tower and speakers as well. I had to drill a hole through the fiberglass to run the wiring to the amps. The tower had holes pre-drilled for the wire.

zeus12
05-16-2007, 10:03 PM
I was expecting the tower to be pre drilled but it was not so I have to drill it now

cst573
05-16-2007, 10:04 PM
I used a rubber grommet in the hole and black flexible wire conduit for the wiring.

cst573
05-16-2007, 10:05 PM
Drill a pilot hole and then you can use a unibit to make it bigger.

dapicatti
05-17-2007, 12:29 AM
Amp was extra on ours, we just upped it to two, and 4 tower speakers and 2 subwoofers. Much better.