PDA

View Full Version : Blower Vent Tubing


sanjuan23
05-08-2007, 09:13 AM
As I was doing a little house cleaning in the bilge I noticed the blower vent tubing was completely shredded. Does anyone if this is the 3" or 4" tubing? Thanks!

TMCNo1
05-08-2007, 09:18 AM
As I was doing a little house cleaning in the bilge I noticed the blower vent tubing was completely shredded. Does anyone if this is the 3" or 4" tubing? Thanks!


It would be best to measure the intake or discharge of the blower to verify and go from there, it's 3" I.D. hose according to Skidim's catalogue.
Also see this thread for some neat info, http://www.tmcowners.com/teamtalk/showthread.php?t=16072

sanjuan23
05-08-2007, 09:23 AM
Well that was my plan this morning but as soon as I got done with all the trash etc. I was already on my way to work before I realized I hadn't measured the tube.

butter
05-08-2007, 02:21 PM
Does anyone if this is the 3" or 4" tubing? Thanks!

In my '92 205, it is 3" hose.

(I discovered my blower hose to be completely missing. I bought new hose from the local boat dealership, but honestly, I think it was just repackaged dryer hose from Lowe's)

sanjuan23
05-08-2007, 02:24 PM
I measured at Lunch it is the 3"

Matt L.
05-09-2007, 01:19 AM
In my '92 205, it is 3" hose.

(I discovered my blower hose to be completely missing. I bought new hose from the local boat dealership, but honestly, I think it was just repackaged dryer hose from Lowe's)

Seriously, go to Walmart in the RV section they have 3" sewer discharge hose. Much heavier than the crap you got. I got the same marina stuff at > double the cost of the RV stuff. I found it after running all new blower hose.

Later,

Matt

east tx skier
05-12-2007, 08:54 PM
Dryer hose is a perfectly good alternative as well.