PDA

View Full Version : Tune Up Tips for 351 HO


alp
04-24-2007, 01:33 PM
After months of trying to decide whether or not to sell the boat, we're keeping it and doing a pretty major tune up.

Any tips from the experts would be appreciated!

I'm mostly concerned about the filters and carb - spilling fuel and removing old/installing new carb.

1. New carb (4160)
2. Fuel filters (fuel pump and water separator)
3. Plugs, wires, cap, rotor
4. Impellor
5. Acme 541

east tx skier
04-24-2007, 02:28 PM
Part Numbers for the Ford 351

Oil Filter is Motorcraft FL1A, Napa Gold 1515, Fram PH-8A or comparable WIX filter (I use the Motorcraft). Lots of folks around here swear that the Fram is utter crap.

Fuel Filter Element is NAPA part # 3943 or #39413 (I've seen both)

Spin on Fuel Filter (early 90s MCs) is WIX #33225 (From NAPA)

Spark Plug Wire Set I recently bought is PCM RA121008/9. Ran about $32 and are precut with right angle boots. OEM wires are Taylor.

Distributor Cap NAPA part # AL171

Rotor is NAPA part # AL163

Spark Plugs for 351 HO are Autolite 764 (Copper), gap 0.035

Impeller is Johnson 812 (splined)

PCV Valve is NAPA Part #2-9210; or Motorcraft # EV-68 2F16 (on the advice of Tommcat, I opted for the motorcraft part).

alp
04-24-2007, 02:52 PM
Thanks. These will be great for future reference #'s. Ordered everything today - hard fuel line from Rambo and everything else from Ski Dim.