PDA

View Full Version : drivers seat removal


c640947
01-20-2005, 05:53 PM
Does anyone know the best way to remove the driver's seat for a 1995 PS190?

The back screws for the slider are tough to get to, even with the seat all the way forward. There are small black screws around the base that go to the floor.

I can only fit my new sub under the front via under the driver's pod because it is too tight going in through the spotter's seat.

Thanks in advance.

Andrew

NatesGr8
01-20-2005, 07:49 PM
I think there's a way to remove the seat from the bracket thats connected to the floor. Try removing the bottom cushion and check if there's any screws or bolts under there.

_JR
01-20-2005, 11:27 PM
you should be able to slide the seat all the way forward and off of the rails that hold it in place.

Farmer Ted
01-20-2005, 11:51 PM
take the bottom cushion off, slide the seat back until the holes in the plastic line up with the screws and you'll be set

c640947
01-23-2005, 10:01 AM
Thanks for the advice - I picked up the cushion and sure enough there are removal holes. Must have had a brain freeze - dont know why I didnt think of that. Thanks again everyone.

Andrew

Mag_Red
01-23-2005, 10:59 AM
You can always depend on good advice here! :headbang:

94PS190
01-23-2005, 03:02 PM
I just removed mine, I think it was the first time it has been removed because the screws were siezed. I had to use an impact driver to get them out. If your not familiar with impact drivers - it is a screw driver you hit with a hammer to loosen stuck screws. Hope this helps.

jimmer2880
01-24-2005, 08:21 AM
you should be able to slide the seat all the way forward and off of the rails that hold it in place.

I can back this up... my '95 PS190 seat will come off by sliding it forward.