PDA

View Full Version : oil pressure gauge


jsonova99
01-06-2005, 10:22 PM
I just installed a new oil pressure sending unit on my '91 PS190 with the 351 in it. I had a hell of time routing it under the fuel line, in fact what kept happening was the fuel line would short against the lead. I ended up wrapping everything heavilyin tape to insulate the two. Has anybody else had a similar problem?

Laurel_Lake_Skier
01-06-2005, 10:32 PM
I was looking at replacing my sending unit and saw the same tight squeeze with the fuel line. I was thinking I'd put a short piece of pipe to extend the sender out a bit. That would put the sender outside (from the block) of the fuel line and give the needed room.

jsonova99
01-06-2005, 10:41 PM
That's actually a really good idea, I think I am going to do the same while I still have everything apart.