PDA

View Full Version : X1 or X2 prop "drive shaft removal"


Loffgren
11-12-2006, 07:51 PM
How do I get the "drive shaft"out of the transmission? I am replacing packing gland...

TMCNo1
11-12-2006, 08:32 PM
Are you replacing the packing in the shaft log? There would be no reason to remove the shaft to replace the packing. Just pull it out with some dental tools and replace with 3 new pieces with the ends spaced 120 degrees apart or just add a piece to it. I seriously hope this is not being done on the '06 in your profile. We have a '89 PS190 and I have only added 1 piece in 18 years and 450 hours.

point1234
11-12-2006, 10:26 PM
It must of been from the mouse in his boat.

Loffgren
11-13-2006, 12:58 PM
It is a one piece packing gland, so the shaft has to come out to slide on the gland. Yes it was from the friggin RAT, thats all i have left to fix YEEEEEEEE

sanjuan23
11-13-2006, 01:54 PM
Maybe I missed it but I assume that the little monster has finally meet his/her demise...

TMCNo1
11-13-2006, 03:07 PM
Nevermind, I forgot about the critter!

Loffgren
11-13-2006, 03:25 PM
I have not found a carcass but he is not in there, could be under gas tank pulling that tonight

Loffgren
11-14-2006, 12:11 PM
Ok, so took the nut off the shaft end next to gas tanks remove the four nuts and bolts from brass/metal spline hub also next to gas tank.
Removed prop used shaft as a slide hammer to pop shaft from spline hub tada!!!