PDA

View Full Version : Shaft seal nut , 04 197


bareinnj
07-10-2006, 09:09 AM
How difficult is it to get the engine cover and rear-center floor piece out so that I can tighten the packing nut a bit. I cannot find visible screws that hold the panel in place. Ideas?

erkoehler
07-10-2006, 09:30 AM
It is very easy, and you should be able to lift the floor/motor box out as one unit.

bareinnj
07-10-2006, 10:10 AM
How/where is is screwed down? My older Mastercrafts had screws visible through the carpets.

jmac197
07-10-2006, 10:32 AM
On my '02 1`97 it is pressure fit. You can take the access cover off with the engine cover if you want to make it quick and easy. Just have a friend help, that thing is too big and heavy for one. Or remove the engine cover from the floor and give a quick tug on the floor. You will want to remove the back seat, because the cover extends to the back of the floor.

Later
Jim

Hillbillytoober
07-10-2006, 10:43 AM
is we suppose to be talkin our shafts and nuts on here??:confused:

bareinnj
07-10-2006, 11:09 AM
So they just squeezed it in there(Hope you like that one, Hillbilly!) ? Makes sense. Cool. Should not be so bad with two of us . No mention of yank or tug with "two of us" in the same sentence, though.