TeamTalk - Livin' in the 80s's Album: Carpet Install

All Mastercraft Boats Knowledge Center Contact Us

Home Team Talk

		TeamTalk > Livin' in the 80s's Profile > Albums
Carpet Install

Mark Forums Read

Carpet Install

Installing the carpet took a lot of patience and a little wrestling it around the curves but well worth the effort. Cleaning and prep took the most time.

Finished Interior with new upholstery, went with neutral color scheme, not sure about the rainbow?

Finished Interior with new upholstery, view of passenger and drives seat

Finished Interior with new upholstery, view from stern. So far the carpet and glue is holding great. I don't soak the boat and let it sit. I keep...

The carpet was a bit thicker than original and there are some "raised nubs" in the carpet design that made the floor panels fit tight, but a sharp...

Here is the rear floor panel removed. I held the carpet back just shy of the gas tank thinking it would facilitate better drainage. the original...

Got the two halves in place using outdoor glue (Roberts 6700), only seam is down the center in the nose. Use the good old, highly flammable, contact...

Rough cut two halves based on old pieces. Left an extra 8 to 12 inches to curl under the side rails and cover the foam. Dry fit and trimmed a...

Save the old pieces to use as patterns. You also need to keep these until you re-install all the seats and pieces that screw into the hull. You...

All times are GMT -4. The time now is 10:04 PM.