Check The Ballast Pump Impeller

This applies only to boats equipped with some type of ballast system. The number of ballast pumps varies from system to system. You may need guidance from your Dealer to locate any and all pumps.
Step 1: Remove two of the cover screws and retain the screws for the reinstallation process. Swing the cover out of the way to allow access to the impeller location.
Step 2: Using the needle-nose pliers, pull the old impeller out of the casing.
Step 3: Install the new impeller. (It is intentionally larger than the case. While gently squeezing it in, ensure that the paddle wheels angle in the same direction--counterclockwise--all the way around.)
Step 4: Slide the plate back into place. No silicone is necessary. Due to the built-in gasket, tightening the screws should prevent leakage.

MasterCraft Team Talk

Recent Forum Activity

  • 1983 Stars & Stripes Restoration

    Looks like your gonna make her better than new. Great work....

    Read More

  • Traxx822's Winter upgrades

    Nice looking wheels. :rolleyes:...

    Read More

  • '89 Prostar 454 Restomod

    Totally Awsome, cant wait for more....

    Read More

News & Announcements

Updates and News From MC

  • BLURRING THE LINES

    Guerrero, Mexico: In the early summer of 2014, we set out on a surf trip like no other.This is a record of that event.Watch the 2015 MasterCraft X20 - "BLURRING THE LINES" (Trailer)...

    Read More
  • MasterCraft Australia Pulled the Championships

    MasterCraft Australia has been busy after successfully pulling both the National Tournament Waterski Championships and the National Wakeboard Championships.And, this was all on top of the Australian Open Waterski Championships. No other boat company ...

    Read More
×